Filter
Top Products
The red Charging light stays on
while the handset is on the base,
even when the batteries are fully
charged.
Talk/Standby time
Under ideal conditions, fully charged
handset batteries should give up
to 8 hours talktime or 80 hours
standby on a single charge.
Battery low warning
The handset battery symbol is
empty and flashing and you will hear
a warning beep. Start recharging
your handset right away.
When charging the battery, level
bars are animated.
Replacing batteries
Use only rechargeable 750mAh or
higher AAA NiMH batteries.
Battery performance
When batteries are fully charged
the display shows red, orange and
yellow level bars.
To keep your batteries in the best
conditions, leave the handset off
the base for a few hours at a time
(after the initial 16 hour charge).
Please note however, that new
NiMH batteries do not reach full
capacity until they have been in
normal use for several days.
2. Insert 2 x AAA NiMH batteries supplied into the handset.
Slide the battery compartment covers into place.
3. Charge the handset for at least 16 hours by placing it on
the base. The red Charging light comes on. The handset
is pre-registered to the base as Handset 1. The screen
shows the standby display.
4. After 16 hours, plug the telephone line cord into the wall
socket and your BT Equinox 1200 base.
8 Getting started
BT Equinox 1200 – Edition 6 – 28.05.04 – 5757
Menu Names
08:16
Equinox 1
5757 Equinox 1200 UG 28/5/04 10:32 am Page 8