Filter
Top Products
79
BT Equinox 1200 – Edition 6 – 28.05.04 – 5757
Access code and entering a pause
If you are connecting your BT Equinox 1200 to a switchboard/PBX you may need to prefix
stored numbers with an access code (e.g. 9) in order to get an outside line. So that the
switchboard has time to pick up an outside line, you may also need to add a Pause after
the access code.
A pause is entered when storing a number in the phonebook (see page 23) or PABX access
code (see page 55) by pressing and holding the button until the display shows
P
.
Dialling mode
With some switchboards/PBXs you may need to switch the dial mode from Tone to Pulse,
otherwise you should not need to adjust this setting.
1. Press MENU then scroll to
Base Settings
and press OK. Press to highlight
Dial
Mode
then press OK.
2. Press or to highlight the setting you want. Press OK to confirm.
General information
5757 Equinox 1200 UG 28/5/04 10:32 am Page 79