Briggs & Stratton Model 040205-0 Telephone User Manual


 
BRIGGSandSTRATTON.COM6
Change switch positions as desired. See
following table for switch settings
Properly position and replace the GenAlert’s back
cover with the phone jack tab (A) over the phone
jack (B).
4.
5.
Plug one end of the telephone cord into GenAlert.
Plug the other end of the telephone cord into the
wall jack of the single line telephone.
Using generally accepted low voltage wiring
techniques, route the two-conductor wire from
GenAlert to the home generator control panel. If
necessary, extend wire lengths as described in
Extending Wire Lengths.
6.
7.
Switch # Function OFF Position ON Position Default Position
1
FACTORY USE ONLY
Do not change
N/A N/A OFF
2
Pick Up Ring Count.
When you call your monitored location, should
the dialer pick up after 5 rings or 10 rings?
10 rings 5 rings ON
3
Call out frequency during an alarm. How often
should the dialer call the pre-programmed
telephone number?
Every
15 minutes
Every
2 hours
ON
4 Alarm Input Position.
Normally
Closed
Position
Normally
Open
Position
ON
B
A