Avaya 5420 + EU24 Telephone User Manual


 
Function Key Programming Function Keys - Page 43
IP Office 5420 + EU24 User’s Guide Function Keys - Page 43
40DHB0002UKEG – Issue 4 (9th February 2004) Function Key Programming
Logof - Extn Logout
Logs the current user off the extension.
This function does not required any data to be entered when programmed. This
function cannot be programmed through the phone by the user.
Pressing
Logof logs the current user off the extension. A new user must then log
on to use the extension or dial *36 to re-associate the extension with its default user.
[User | Digital Telephony | Advanced | Extn | Extn Logout]
Music - Hold Music
Plays the telephone system's music on hold.
This function does not required any data to be entered when programmed. This
function cannot be programmed through the phone by the user.
Pressing Music plays the telephone system's music on hold through the extension.
[User | Digital Telephony | Advanced | Hold | Hold Music]
NATim - Set No Answer Time
Sets the extension's no answer time after which ringing calls are forwarded or go to
voicemail.
This function requires the time in seconds to be entered when programmed. The value
is shown next to NATim. This function cannot be programmed through the phone by
the user.
Pressing
NATim sets the extension's busy wrap up time to the indicated number of
seconds. This time is used to set a delay between ending one call and the next call
ringing the extension (the waiting call may be indicated on the display however).
[User | Digital Telephony | Advanced | Set | Set No Answer Time]
See also:
WUTim - Set Wrap Up Time on page 52.
OCSeq - Set Outside Call Sequence
Sets the ringing pattern (sequence) used for internal calls.
This function is currently not supported on the 5420 telephone.
Page - Page
Page the specified target extension or group. The target must be capable of hands-free
speech.
This function requires the target extension or group number to be specified when
programmed. The target is then shown next to
Page. This function cannot be
programmed through the phone by the user.
[User | Digital Telephony | Advanced | Dial | Dial Paging]
See also:
GrpPg - Group Paging (!)on page 38.