Filter
Top Products
Page 42 - Function Key Programming Function Keys
Page 42 - Function Keys IP Office 5420 + EU24 User’s Guide
Function Key Programming 40DHB0002UKEG – Issue 4 (9th February 2004)
ICSeq - Set Inside Call Sequence
Sets the ringing pattern (sequence) used for internal calls.
This function is currently not supported on the 5420 telephone.
IDial - Dial Intercom
The same as IAuto - Automatic Intercom on page 41. This function cannot be
programmed through the phone by the user.
[User | Digital Telephony | Emulation | Dial Intercom]
Inclu - Dial Inclusion
Intrudes on a call in progress at the target extension.
This function is currently not supported on the 5420 telephone.
Intru - Call Intrude
Intrudes on a call in progress at the target extension, creating a conference between
the callers and the intruding extension.
This function requires entry of the target extension number when programmed. The
Intru key shows the target extension number. This function cannot be programmed
through the phone by the user.
Pressing
Intru intrudes on the call in progress.
Note: That the System Administrator must configure the intruding extension as being
able to intrude. Additionally none of the other extensions involved in the call can
have "Cannot be intruded on" status.
[User | Digital Telephony | Advanced | Call | Call Intrude]
Listn - Call Listen
Allow the extension to listen to groups calls to the target extension. The call parties
cannot hear the listening extension.
This function requires entry of the target extension number when programmed. This
function cannot be programmed through the phone by the user.
The
Listn key shows the target extension number.
Use of this function requires setup of the extension's monitor group by the System
Administrator. This function requires the telephone system to have some free
conference capacity when invoked.
[User | Digital Telephony | Advanced | Call | Call Listen]
See also:
• Intru - Call Intrude on page 42.
• Recor - Call Record on page 50.
• Steal - Call Steal on page 50.
Login - Extn Login
Logs the current user onto the extension.
This function does not require any data to be entered when programmed. The user
cannot program this function through the phone. Pressing the soft key login prompts
the user Enter Extn:. The user enters the desired extension and presses the soft
function key Next. The user is prompted for the password. The user enters the
password and presses the soft function key “Done.”
[User | Digital Telephony | Advanced | Extn | Extn Login]