Filter
Top Products
3600 Series Wireless Phone User Guide
3600 Series Wireless User Guide Page 26
IP Office [15-601104] Issue [1] (1 June 2006)
To charge your phone with a desktop charger:
1. Place the desktop charger on a flat, horizontal surface and plug the power supply into the
desktop charger and then into an appropriate wall outlet.
2. To end any call in progress, press End Call before you place your phone into the desktop
charger. Your phone can be off or in standby mode during charging.
3. Place your phone into the desktop charger slot, facing forward.
If the phone is placed correctly, the red indicator will come on. The indicator light will not come on if the
slot is empty, if the phone is improperly seated or when the desktop charger has no power applied.
While the phone is charging in standby mode, the extension number and Charging...is displayed The
battery icon will show charging progress. The phone is fully operational and will ring if called.
While the phone is charging while turned off, only Charging...is displayed and no calls will be received.
The dots race during the charging cycle. It is normal for the battery pack to become warm whilst
charging.
Your phone is fully charged when Charge Complete is displayed. The indicator light will remain on until
the phone is removed.
Dual Chargers
The Dual Charger is a two-slot desktop charger.
DCE200 is designed to charge the BPE100 Battery Pack in the 3616 phone and a spare BPE100
Battery Pack.
DCN200 is designed to charge the BPN100 Battery Pack in the 3620 phone and a spare BPN100
Battery Pack.
DCX200 is designed to charge the BPX100 Battery Pack in the 3626 phone and a spare BPX100
Battery Pack.
3616 Phone in DCE200 Dual Charger 3626 Phone in DCX200 Dual Charger
The models are not interchangeable. Full charging is accomplished in approximately one and a half to
two hours for either slot.
To set up the dual charger, you must first obtain an appropriate Avaya power supply for your country or
region.