Filter
Top Products
Display Keys Page 33
2420 User Guide Page 33
IP Office 40DHB0002USEG - Issue 1 (29/04/2003)
DPkUp - Directed Call Pickup (!)
Answer a call currently ringing at a specified user or group.
This function requires entry of the target extension or group number. The
DPkUp key displays that number. This function can be programmed
through the phone by the user using an
Admin key.
When a call is ringing at the extension or group, press
DPkUp to
answer (pick up) that call.
[User | Button Programming | Emulation | Directed Call Pickup]
Drop - Drop (!)
Clears a current calls. Temporarily pauses the ringing of an incoming call.
This function does not require any data entered when programmed. This
function can be programmed through the phone by the user using an
Admin key.
For an incoming call ringing the extension, pressing
Drop switches off
the ringing for a few seconds before ringing again. Note: If the timers for
forwarding or diversion to voicemail expire during the silent period, those
actions will occur without the call ringing at the extension again.
For a call in progress, pressing
Drop disconnects the caller.
[User | Button Programming | Emulation | Drop]
DTone - Secondary Dial Tone
Return secondary dial tone to the user.
This function does not require any data entered when programmed. This
function cannot be programmed through the phone by the user.
Pressing
DTone gives the user dial tone. They can then dial the
telephone number they require.
This function is not available or supported on all system locales.
[User | Button Programming | Advanced | Dial | Secondary Dial Tone]
Emrgy - Dial Emergency
Dials a specified number regardless of any call barring applied to the user.
This function requires entry of a number to dial when programmed. That
number is then shown next to Emrgy. This function cannot be programmed
through the phone by the user.
[User | Button Programming | Advanced | Dial | Dial Emergency]
Flash - Flash Hook (#)
Send a hook flash signal to the currently connected line.
This function does not require any data entered when programmed. This
function cannot be programmed through the phone by the user. This
function can be programmed through the phone by the user using an
Admin 1 key.
[User | Button Programming | Advanced | Miscellaneous | Flash Hook]