Filter
Top Products
60
Appendix C
Adding and registering handsets
PRESS HNDST LOC
4 SEC ON BASE
PLEASE WAIT...
HS X REGISTERED
To register a handset to your telephone base
1. Place the unregistered handset into the telephone
base. If PRESS HNDST LOC 4 SEC ON BASE does not
appear on the handset screen after a few seconds,
remove the handset and place it in the telephone
base again.
2. On the telephone base, press and hold HANDSET
LOCATOR for about four seconds (until the red
IN USE light on the telephone base turns on) and
then release the button. The handset will show
PLEASE WAIT... and it will take about 10 seconds
to complete the registration. The handset will show
HS X REGISTERED and will beep if the registration is
successful.
NOTES:
1. If the registration is not successful, the display will show NOT
REGISTERED. To reset the handset, remove the handset from the
telephone base and place it back in. Try the registration process
again.
2. You cannot register a handset if any other system handset is in use.