Filter
Top Products
37
Answering system
RECORD
ANNC.
Press ON/OFF until
the system announces
“Calls will not be
answered.”
"Beep."
The system has been
turned off.
1.
2.
Answering system mode
The answering system’s default factory setting is
ON in order to answer and record messages. You
can turn the answering system off, but if you do
so, the answering system will not answer calls or
record incoming messages.
Turn the answering system off
Press ON/OFF until you hear “Calls will not be
answered” and a confirmation beep. The
ON/OFF will be turned off.
NOTE: If the answering system is off and someone calls,
the telephone will ring 10 times then answer and
announce “Please enter your remote access code.” Enter
your remote access code to enter remote access mode
(page 38). If you do not enter the correct remote access
code, the call will be ended automatically.
Turn the answering system on
Press ON/OFF until you hear “Calls will be
answered” then a beep to confirm the ON setting.
The ON/OFF light will be turned on.
Call screening
If the answering system is on and the telephone
base volume is not set to off, you will hear the
announcement and the incoming message when a
call comes in.
Call intercept
While you are call screening, you can intercept
the call by pressing PHONE/FLASH on the
handset.
-OR-
Press ON/OFF until the
system announces “Calls
will be answered.”
"Beep."
The system has been
turned on.
2.
1.