Filter
Top Products
33
Answering system
"Number of rings," current
setting, then "To change
the setting press SKIP
or REPEAT; to continue
setup, press SETUP."
Options: 2/4/6/toll saver
“Base ringer,” current
setting, then “To change
the setting, press SKIP or
REPEAT
; to continue setup,
press SETUP.”
Options: high/low/off
"Remote access code,"
current setting, then
"To change the setting
press SKIP or REPEAT;
to continue setup, press
SETUP."
Options: (select a two-digit
code) 19
"Message alert tone,"
current setting, then
"To change the setting,
press SKIP or REPEAT;
to continue setup, press
SETUP."
Options: on/off
Choose number of rings before
the system answers a call. When
toll saver is active, the system
answers after two rings if you
have new messages, and after
four rings if you have no new
messages. If you are making a
long distance call to retrieve
messages, you may disconnect
your call after three rings so that
there will be no long distance
charge incurred.
Choose the telephone base
ringer volume between high and
low level, or turn the telephone
base ringer off.
Select a two-digit number (10-
99) for remote access from
another telephone (page 38).
When on, the telephone beeps
every 10 seconds when there are
new messages.
NOTE: Press and hold
SKIP
or
REPEAT
to increase or
decrease the remote access
code number by 10.
NOTES:
1. The message alert tone
will beep only if all the
conditions below are met:
Answering system is on;
Message alert tone setting
is on;
There are new messages.
2. Press any base key to
temporarily silence the
message alert tone. If you
press DELETE twice when
the phone is not in use, you
will delete all old messages
and the message alert tone
will be temporarily silenced.
The message alert tone will
be re-activated with the
next incoming message.
RECORD
ANNC.
Changing feature options
You can set and change the answering system
features described below:
1. Press SETUP repeatedly until you hear the
feature you want to modify.
2. Press SKIP or REPEAT to change the
setting.
3. Press SETUP to set your selection and move to
the next menu option.
4. Press PLAY/STOP to confirm the setting and
exit the menu.
Feature options (Default settings underlined)
System announces: Feature description: