Filter
Top Products
31
Answering system
RECORD
ANNC.
Day & time announcements
Check day & time
You can press CLOCK at any time to hear the
current day and time without changing it.
Set day & time
Before playing each message, the answering
system announces the date and time when the
message was received.
Follow the steps below to set the day, time and
year, so that messages are dated correctly. Each
time you press SKIP or REPEAT, the day, hour,
minute or year increases or decreases by one.
Press and hold SKIP or REPEAT to increase or
decrease the minutes or year by increments of 10.
When you hear the correct setting, press CLOCK
to move to the next setting.
1. Press CLOCK, The system will announce the
current clock setting, then announces “To set
the clock, press CLOCK.”
2. Press CLOCK, The system will announce the
current day setting, then announces “To change
the day, press SKIP or REPEAT, to change
the hour, press CLOCK.”
3. Press CLOCK, The system will announce the
current hour setting, and then announce “To
change the hour, press SKIP or REPEAT, to
change the minute, press CLOCK.”
4. Press CLOCK, The system will announce the
current minute setting, and then announce “To
change the minute, press SKIP or REPEAT, to
change the year, press CLOCK.”
5. Press CLOCK, The system will announce the
current year setting, and then announce “To
change the year, press SKIP or REPEAT, press
CLOCK when you are done.”
6. Press CLOCK. The system announces the
current clock setting.
NOTES:
1. If the clock was not set
when the message was
recorded, the system will
announce "Time and day
not set."
2. Caller ID provides the
time and date. Set the
year so that the day
of the week can be
calculated from the caller
ID information. The time
will be set automatically
only if you subscribe to
caller ID service provided
by your local telephone
company (page 25).