AT&T E5902B Cordless Telephone User Manual


 
Appendix
49
The charge light
is off
Clean the cordless handset and telephone base
charging contacts each month using a pencil eraser
or cloth.
Make sure the power and line cords are plugged in
correctly and securely.
Unplug the unit’s electrical power. Wait for 15 sec-
onds, then plug it back in. Allow up to one minute for
the cordless handset and telephone base to reset.
Your phone might be malfunctioning. Please refer to
the Limited warranty section of this user’s manual
for further instruction.
Troubleshooting
Common cure for
electronic equip-
ment
If the unit does not seem to be responding normally,
try putting the cordless handset in its base. If it does
not seem to respond, do the following (in the order
listed):
Disconnect the power to the telephone base.
Disconnect the cordless handset battery, and spare
battery, if applicable.
Wait a few minutes.
Connect power to the telephone base.
Re-install the battery pack, and place the cordless
handset into the telephone base.
Wait for the cordless handset to re-establish its con-
nection with the telephone base. To be safe, allow up
to one minute for this to take place.