Filter
Top Products
Wall Installation
1 Remove the base.
Place your thumbs in the two openings at the large end of the
base. Push down with your thumbs, and lift the base up and away
from the phone.
2 Connect the bundled line cord(s) to the telephone.
Leave the telephone line cord(s) bundled.
• If you have a two-line jack, use only the line cord with the
clear modular plugs on each end. Plug one end into the jack
labeled L1 OR L1/2 on the back of the telephone.
• If you have two separate jacks, use both line cords. Leave
the cord with the blue plugs bundled. Insert one end of this
cord into the jack labeled L1 OR L1/2 on the back of the
telephone. Unbundle the cord with the clear plugs. Insert
one end of this cord into the jack labeled L2 on the back of
the telephone.
3 Attach the base.
Turn the base so that the larger end of the base is toward the
bottom of the telephone. Attach the base by inserting the tabs into
the slots. Push down on the large end of the base so the tabs are
in the slots, and the base locks in place.
4 Reverse the handset tab.
This tab holds the handset
when you hang up. Hold down
the switchhook, and slide the
tab up and out of its slot. Turn
the tab so that the end with the
“hook”is up, then insert the tab
back into its slot.
5 Connect the power cord to the phone.
Fit the power cord behind the strain relief tab. Then plug the
smaller end of the power cord into the jack labeled POWER at the
back of the system.
6 Connect the line cord(s) to your modular jack(s) and mount
the phone onto the wall.
• If you have a two-line jack, plug the free end of the line cord
into a modular wall jack. Make sure the cord snaps firmly into
place. Place the phone on the wall jack mounting studs and
pull down until it is held securely.
INSTALLATION
5
Figure 1 Figure 2 Figure 3