Filter
Top Products
TELEPHONE OPERATION
16
Switching Between Lines During a Call
During a call on one line, you can make or answer a call on the other line
by pressing H. You can use the H and Line buttons to switch back
and forth between calls as often as necessary.
For example: With Automatic Line Selection on, while you are using Line 1,
Line 2 rings.
1 Press H to hold Line 1.
2 Press l to select the line for the incoming call, then lift the
handset or press S to answer the call.
3 Press L to hang up Line 2 and return to your first call
— OR—
Press H to hold Line 2, and press L to return to your
first call.
Mute
This feature lets you mute the line you’re on so that you can hear the other
party, but the other party can’t hear you.
To activate this feature, press and release M. The MUTE light goes on.
To return to normal conversation, press and release M again.
NOTE: Switching from handset to speakerphone or from speakerphone to
handset also cancels Mute.
Conference Calls
You can use both lines at the same time to set up a three-way conference call.
1 Answer or make a call on one line,then put the call on hold.
2 Press the other line button, and make or answer another call.
3 Press C to connect all parties. The red LINE lights for both
lines are lit during a conference call.
If one party hangs up during a conference call, you might hear a dial tone.
Press the Line button of the remaining call to disconnect the other line and
eliminate the dial tone.
NOTE: Under certain circumstances, the far-end parties on a conference
call may not hear one another clearly.