Filter
Top Products
6
INSTALLATION
Table/Desk Installation
1 Choose a spot near an electrical outlet and a telephone jack.
• This phone requires a modular telephone jack and a standard
electrical outlet not controlled by a wall switch.
2 Install the handset battery.
• Remove the battery compartment cover on the handset by
pressing on the indentation and sliding the cover downward.
• Plug the battery pack connector into the handset and place the
battery pack in the case, so the wires rest between the battery
pack and the case.
• Place the battery case compartment on the handset by sliding it
on its track up over the battery compartment until it snaps firmly
in place.
NOTE: The new batteries must be charged before using this telephone.
Place the handset in the base unit and allow it to charge for four hours.
The telephone may operate before that, but, for best performance, let
the batteries charge fully.
3 Set the handset RINGER switch.
Set the switch on the side of the handset to ON so the handset will
ring. When this switch is set to OFF, the handset will not ring.
NOTE: If you set the handset RINGER switch to OFF, the handset
battery will last longer. However, when the handset RINGER switch is
set to OFF, no incoming call information will appear in the display, the
handset will not ring, and the Page/Intercom and Handset Locator
features are inactive.
Battery
compartment
cover
Battery pack
Handset