Filter
Top Products
TELEPHONE OPERATION (From the Base)TELEPHONE OPERATION (From the Handset)
Page
The Page feature allows you to signal someone at the handset from the base.
• Make sure the Handset In Use light is not lit on the base.
• Press on the base. A three-part paging tone will
sound at the handset.
*
NOTE: The handset Ringer Switch must be set to ON to operate the
PAGE feature.
Handset Locator
This feature is useful if you misplace the handset.
To locate the handset using this feature:
• Press and hold on the base for approximately four
seconds. A repeating paging tone is sounded in the handset.
To cancel the handset locator feature:
• Press on the handset or on the base.
*
NOTE: The Handset Locator feature will turn itself off in approximately
three minutes if you haven’t turned it off before then.
Mute
The Mute feature allows you to hear your caller, but prevents the caller from
hearing you.
To activate the Mute feature:
• Press .
• The MUTE/LOW BATT light will go on and the caller will not be able to
hear you.
To let the caller hear you again:
• Press .
• The MUTE/LOW BATT light will go off and the caller can hear you again.
Temporary Tone
*
NOTE: If you have touch tone service, you do not need to use the
Temporary Tone feature.
If you have dial pulse (rotary) service, this feature allows you to enter codes or
tones needed to operate certain answering machines or to use electronic bank-
ing services, calling cards, and other special services. This feature will operate
most special services; however, some services may actually require a touch
tone line. To be sure, ask the company that provides the special service.
1 Dial the call, then press . Any dial buttons pressed after this send
tone signals.
2 After you hang up, the phone automatically returns to dial pulse (rotary)
dialing.
Recording a Telephone Conversation
Once you have established a connection with the answering system, you can
record a telephone conversation. The telephone conversation will be recorded
along with other messages.
1 While you are having a conversation on the cordless handset, press
and wait for the ANS SYS light to go on to show that you have
made a connection with the answering system. Press .
2 The system will beep once and start recording from the telephone line. The
recording will be treated as a new message.
3 To stop recording, press .
1110