Filter
Top Products
• Mount the base on the wall by holding the base so that the mounting
knobs on the standard wall jack will fit into the keyhole slots on the
base. Slide the base bracket down onto the knobs until it locks into
place. The cradle will support the handset when the base is on
the wall.
• Plug the AC adapter on the power cord into an electrical outlet.
See note under Item 4.
5 Position the base antenna so that it points upwards.
6 Charge the handset batteries before use.
Place the handset in the base. The CHARGING light on the base goes on
to show the handset is in the right position to charge the batteries. This
phone requires 10 hours of charging. The handset will not operate until the
batteries are charged.
7 Check for dial tone.
After the batteries are charged, pick up the handset. Check for dial tone by
pressing ; the PHONE light should go on and you should hear a
dial tone. Press again to turn the phone off.
8 Set the dial mode.
If you have touch tone service, the phone will be ready to use as soon as
the battery is charged.
*
NOTE: If you have dial pulse service you will need to set the dial mode
by pressing , , , , . To return to touch tone
dialing with touch tone service, press , , , , .
when the phone is OFF.
TELEPHONE OPERATION (From the Handset)INSTALLATION
Making a Call
1 Press on the handset. The PHONE light will go on.
2 When you hear a dial tone, dial the number.
Answering a Call
If the handset is in the base:
1 Lift the handset.
2 The PHONE light goes on and the call will be connected.
If the Ringer Switch is set to OFF, or if the handset is away from the base:
1 Press on the handset.
2 The PHONE light goes on and the call will be connected.
*
NOTE: Although ringing will stop when you answer, you might not be
able to hear the other party until the PHONE light goes on steadily.
Ending a Call Using the Handset
If you are near the base:
• Place the handset in the base.
If you are away from the base:
• Press .
Handset Volume
The handset VOLUME button allows you to increase or decrease the loudness
of an incoming voice. The handset volume can be set to three different levels.
Each time you press VOLUME, the level changes.
Flash
Press to activate custom calling services such as Call Waiting or
Three-Way Calling. You may have to press other buttons before or after
as explained in the custom calling instructions provided by your local
phone service company.
Redial
The last number dialed (up to 16 digits) on the phone is stored in redial
memory until you dial another number.
1 Press and wait for the PHONE light to go on.
2 When you hear a dial tone, press .
98
Power cord
Plug into
electrical outlet
Plug into base unit
Plug into modular
phone jack
Plug into back of
base unit
Telephone line cord