Filter
Top Products
24
TELEPHONE MEMORY
This telephone can store 13 telephone numbers, each up to 32 digits. Dial the
numbers stored in memory by pressing one or two buttons.
Storing Numbers in Memory
1. Lift the handset.
2. Press and release PROG.
3. Dial the telephone number
(up to 32 digits) or press
PAUSE/REDIAL to store
the last number dialed from
this telephone.
4. For one-touch dialing, press
and release the memory but-
ton where the number is to
be stored (M1, M2, or M3).
For two-touch dialing, press
MEMORY, then press the
number button (0-9) where
the number is to be stored.
Storing a CID Call Record into
Memory
1. Lift the handset.
2. Press p or qto display the
call record to be stored in
memory.
3. Press PROG.
4. Go to step 4 above under
Storing Numbers in
Memory.
NOTES:
• If you pause for over 10 sec-
onds when programming an
entry, the procedure will time-
out and you will have to begin
again.
• If you have difculty storing
numbers in memory, please see
Difculty storing numbers
in memory on page 31.
• Each 3.6 second pause counts
as one digit when storing num-
bers in telephone memory.
Storing a Pause
in a Memory
Number
Press and release
PAUSE/REDIAL
once to store a
3.6 second pause
in the dialing se-
quence, twice for
a 7.2 second delay,
three times for a
10.8 second delay.