Filter
Top Products
2-262-26
2-262-26
2-26
Chapter 2: Hardware informationChapter 2: Hardware information
Chapter 2: Hardware informationChapter 2: Hardware information
Chapter 2: Hardware information
NEVER connect a
USB cable USB cable
USB cable USB cable
USB cable to the IEEE 1394a connector. Doing so
will damage the motherboard!
8.8.
8.8.
8.
IEEE 1394a connector (10-1 pin IE1394_1)IEEE 1394a connector (10-1 pin IE1394_1)
IEEE 1394a connector (10-1 pin IE1394_1)IEEE 1394a connector (10-1 pin IE1394_1)
IEEE 1394a connector (10-1 pin IE1394_1)
This connector is for an IEEE 1394a port. Connect the IEEE 1394a
module cable to this connector, then install the module to a slot
opening at the back of the system chassis.
A8R-MVP
®
A8R-MVP IEEE 1394 connector
IE1394_1
1
GND
+12V
TPB2-
GND
TPA2-
+12V
TPB2+
GND
TPA2+
9.9.
9.9.
9.
Chassis intrusion connector (4-1 pin CHASSIS)Chassis intrusion connector (4-1 pin CHASSIS)
Chassis intrusion connector (4-1 pin CHASSIS)Chassis intrusion connector (4-1 pin CHASSIS)
Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or
switch. Connect one end of the chassis intrusion sensor or switch
cable to this connector. The chassis intrusion sensor or switch sends a
high-level signal to this connector when a chassis component is
removed or replaced. The signal is then generated as a chassis
intrusion event.
By default, the pins labeled “Chassis Signal” and “Ground” are shorted
with a jumper cap. Remove the jumper caps only when you intend to
use the chassis intrusion detection feature.
A8R-MVP
®
A8R-MVP Chassis intrusion connecto
r
CHASSI
S
+5VSB_MB
Chassis Signal
GND
(Defaul
t)