Filter
Top Products
ASUS A8R-MVPASUS A8R-MVP
ASUS A8R-MVPASUS A8R-MVP
ASUS A8R-MVP
5-255-25
5-255-25
5-25
5.4.15.4.1
5.4.15.4.1
5.4.1
Installing hard disksInstalling hard disks
Installing hard disksInstalling hard disks
Installing hard disks
The motherboard supports Ultra DMA 133/100/66 and Serial ATA hard
disk drives. For optimal performance, install identical drives of the same
model and capacity when creating a disk array.
Installing Serial ATA (SATA) hard disksInstalling Serial ATA (SATA) hard disks
Installing Serial ATA (SATA) hard disksInstalling Serial ATA (SATA) hard disks
Installing Serial ATA (SATA) hard disks
To install the SATA hard disks for a RAID configuration:
1. Install the SATA hard disks into the drive bays.
2. Connect the SATA signal cables.
3. Connect a SATA power cable to the power connector on each drive.
5.4.25.4.2
5.4.25.4.2
5.4.2
ULIULI
ULIULI
ULI
®®
®®
®
RAID configurations RAID configurations
RAID configurations RAID configurations
RAID configurations
The ULI
®
RAID controller supports RAID 0, RAID 1, RAID 0+1, RAID 5, and
JBOD configurations. Use the ULI
®
RAID BIOS Setup utility to configure a
disk array.
Entering the ULIEntering the ULI
Entering the ULIEntering the ULI
Entering the ULI
®®
®®
®
RAID BIOS Setup Utility RAID BIOS Setup Utility
RAID BIOS Setup Utility RAID BIOS Setup Utility
RAID BIOS Setup Utility
To enter the ULI
®
RAID BIOS setup utility:
1. Boot up your computer, and press <Del> during POST to enter the
BIOS setup.
2. In the
Main MenuMain Menu
Main MenuMain Menu
Main Menu, go to
Storage ConfigurationStorage Configuration
Storage ConfigurationStorage Configuration
Storage Configuration, and set the
Onboard SATA Boot ROM Onboard SATA Boot ROM
Onboard SATA Boot ROM Onboard SATA Boot ROM
Onboard SATA Boot ROM item to [Enabled].
3. Press <F10> to save the changes and exit.
4. During POST, press <Ctrl+A>.
The RAID BIOS setup screens shown in this section are for reference
only, and may not exactly match the items on your screen.
You may also set the RAID configurations in Windows
®
OS after you
have installed the Serial ATA RAID driver. See section “5.2.4 Make
Disk menu” for details.