26
Setting stations to receive calls and
zones to receive paging from remote sites
[Remote site pilot call setting]
Set the master stations and sub stations to receive calls, and
zones to receive paging from remote sites.
The setting can be made for each priority individually.
*
Click
1
Remote site pilot call setting in the table of
contents.
Make the setting by clicking
2
Advanced settings
for
the setting items
G
,
H
,
I
respectively to open the
corresponding window.
Make the setting in the displayed window(s).
3
See the detailed instructions for
G
,
H
,
I
on the
right column of this page.
After the setting is fi nished on the corresponding
4
window, click
Close
to close the window.
Click
5
Temporarily stored
to save the current setting
results temporarily.
If you wish to cancel the setting results you have made,
*
click a title in the table of contents or “Refresh” in the
web browser menu.
*1: The settings on this item are available for a call from the
standard (IP) system in a remote site. The setting method is
the same as the item
H
. (Refer to the “SETTING MANUAL”
for a standard (IP) system for details.)
*2: Not available
G
Settings on [Remote site master call] setting
window
You can set a station (master station or door station) that
receives a call from a master station in a remote site. One
station can be set for each priority.
Click
1)
Reference
for “Normal”.
All the registered stations are displayed in the list in
another window.
Check the box for the target station in the list, and then
2)
click
Close
.
The current window closes and the set station is
displayed in the [Remote site master call] setting
window.
To delete a set station
Click
Delete
for "Normal".
Selecting another station also overwrites the previous
*
one.
Make the setting for “Priority” and “Urgent” in the same way.
H
Settings on [Remote site door call] setting
window
You can set up to 20 master stations that receive a call
from a door station in a remote site. Up to 20 master
stations can be set for each priority.
Click
1)
Reference
for “Normal”.
All the registered master stations are displayed in the
list in another window.
Check the boxes for the target master stations in the
2)
list, and then click
Close
.
The current window closes and the set stations are
displayed in the [Remote site door call] setting window.
To delete a set station
Check the box for the target station and click
Delete
.
You can also select two or more stations and delete
*
them at a time.
Make the setting for “Priority” and “Urgent” in the same
way.
I
Settings on [Remote site paging] setting window
You can set a zone that receives paging from a remote
site. One zone can be set for each priority.
Select the target zone from the pull-down menu for
1)
“Normal”.
Make the setting for “Priority”,“Urgent”and “Broadcast”
*
in the same way.
G
H
I
*2
*1