Filter
Top Products
25
GETTING STARTED USING THE SYSTEM APPENDIX
SETTING THE SYSTEM
Setting the timer [Timer setting]
Set the time for each operation.
Click
1
Timer setting in the table of contents.
Set the time for the following operations respectively.
2
The setting range is displayed on the right side of each
*
input box.
[Call]:
•
Set the duration of call from door stations to [Normal],
[Priority] or [Urgent].
[Communication]:
•
Set the duration of communication between stations in
the system including between remote sites [Via IP].
[In Local] and [Telephone]: Not available in a network
*
direct system.
[Paging]:
•
Set the duration of paging.
[Monitor]:
•
Set the duration of monitoring only one station.
[Scan monitor: Switching]:
•
Set the duration of monitoring each station while scan-
monitoring.
NOTE:
The actual duration slightly differs from the setting value.
[Contact output]:
•
(Not available)
[Door release]:
•
Set the duration of door release.
If you set the time to “0”, the door is released while
*
the door release button on the master station is held
down.
Click
3
Temporarily stored
to save the current setting
results temporarily.
If you wish to cancel the setting results you have made,
*
click a title in the table of contents or “Refresh” in the
web browser menu.