Filter
Top Products
13
GETTING STARTED USING THE SYSTEM APPENDIX
SETTING THE SYSTEM
STARTING UP THE SYSTEM AND PREPARING FOR THE SETTINGS
The system settings are mainly made on the PC by accessing the web browser for the settings incorporated with the IP unit as the IP
host unit. It is recommended to use only one PC for the settings that is connected to the system.
System requirements for PC
Your PC and operating environment must meet the following system requirements to make the settings.
Network 10BASE-T Ethernet, 100BASE-TX Ethernet
Web browser Internet Explorer 6.0 or later (with Internet Options SSL 3.0 enabled)
Starting up the system
Connect a PC to the IP unit.
1
[When connecting a PC to the IP unit via a hub
(switch)]
RJ45
RJ45
RJ45
RJ45
NOTES:
Be sure to connect the CAT5e/6 cable to the LAN ports of both
•
units.
The IP address of IP unit is set to (192.168.0.40) and Subnet
•
Mask is set to (255.255.255.0) as default. Change the IP
address of your PC if needed.
[When connecting a PC to the IP unit directly]
RJ45
RJ45
NOTES:
When connecting a PC to the IP unit directly, use an Ethernet
•
crossover cable.
The IP address of IP unit is set to (192.168.0.40) and Subnet
•
Mask is set to (255.255.255.0) as default. Change the IP
address of your PC if needed.
IP master station
(IS-IPMV)
IP master station
(IS-IPMV)
or
or
IP video door station
(IS-IPDV or IS-IPDVF)
IP video door station
(IS-IPDV or IS-IPDVF)
100m (330')
10BASE-T/100BASE-TX
CAT5e/6 (Crossover cable)
100m (330')
10BASE-T/
100BASE-TX
100m (330')
10BASE-T/
100BASE-TX
CAT5e/6
(Straight-through cable)
CAT5e/6
(Straight-through
cable)
Hub
(Switch)
LAN/PoE
LAN/PoE
PC
PC
(Continued on next page)