Filter
Top Products
- 31 -
8-5
Programming (GH-NS)
a. Programming with a PC
• You can use a PC to enter data and write in or change resident
names.
• Use the connection cable that comes with GH-NS to connect
your PC to GH-NS.
• In your PC, install the setup tool program from the CD that
comes with the GH-BC.
∗ For information on how to use the setup tool, see the text (.txt)
file that is installed in the same folder as the setup tool (.exe).
Save programmed data and resident information data to your
PC is recommended.
b. Programming with GH-NS and GH-10K
• Confirm that "Welcome" is shown on the Display, indicating
that the system is in standby mode.
∗ You can change the "Welcome" text.
• First, set the system to program mode. (For details, see above.)
∗ Before you begin programming, we recommend that you
register a new exclusive ID code for yourself so that the
system is not accessed by others. (For details, see 8-6.)
If you have forgotten your ID code, set the switch (#1) to ON
for approximately 2 seconds. The ID code will be reset to the
default setting of "∗1111".
NOTE: To display only resident name without room number; Set
the switch (#2) to ON.
b
a
GH-NS
PC
1
ON
1
2 3 4
ON
Enter Program Mode
WELCOME
INITIAL ID CODE
INITIAL ID CODE
DISPLAY
Select Menu & Quit
YOUR OPERATION
RE-ENTER ID CODE
YOUR OPERATION
SELECT LANGUAGE
DISPLAY
MENU
Standby
FORWARD
Scroll
BACKWARD
Go to Menu 1-8
1
2
3
4
5
6
7
8
9
SELECT LANGUAGE
CHANGE ID CODE
ACCESS CODE
RESIDENT INFO
SET TIMER
CHANGE GREETING
TRANSFER DATA
SCROLL SPEED
QUIT
1 1 1 1
ID CODE = + 4 digit
1 1 1 1
DECIDE & BACK
DECIDE & NEXT
2
ON