Filter
Top Products
2-12
Getting Started and Using Masks
To understand the Mask Test tab description area
To understand the Mask Test tab description area
After you have enabled the mask test in the Mask Test Setup dialog box, you
will see a Mask Test tab on the lower left of the oscilloscope screen, beneath
the waveform viewing area. The description area below the Mask Test tab
shows:
• Mask title
• Amplitude specifics (for ANSI T1.102 North American Standard Masks only)
• Total number of waveforms in the duration of the mask test
• Number of failed waveforms in the mask test
• Regions in the mask
• Waveform violations
When any of the ANSI T1.102 North American Standard Masks are loaded, the
Mask Test tab description area will show minimum and maximum amplitude
values. These values are the result of testing for specifics of the standard, and
indicate the upper or lower limit that the standard allows.
Mask Test tab
Description area