Filter
Top Products
2-7
Getting Started and Using Masks
To get your waveform on the oscilloscope display
To get your waveform on the oscilloscope display
When doing mask testing, you will try to fit the mask to your waveform. This
is how you will verify whether your waveform meets the acceptable electrical
parameters defined by the standard mask. By having your waveform displayed
on the oscilloscope screen before doing mask testing, when you load and use
the mask, you will know immediately if the waveform passes the mask test.
1
Display the waveform you want to test on the oscilloscope screen.
2 Begin mask testing using a standard mask, as described in the following
topics.