Filter
Top Products
Total Access 600 Series System Manual Section 4 User Interface Guide
61200624L1-1B © 2004 ADTRAN, Inc. 81
INTERFACES (DSX) > TEST > REM LB
Sends a loopback command across the network to a remote unit over the FDL, which causes the remote
unit initiate a local
L
INE
or P
AYLOAD
loopback (whichever is specified). The remote loopback is only
available when the T1 is configured for ESF mode.
INTERFACES (DSX) > TEST > TEST STATUS
Indicates whether a test is in progress.
I
NTERFACES
(ETH)
View the Ethernet interface status and configure the Ethernet parameters from this menu.
INTERFACES (ETH) > CONFIG
Configure the various Ethernet parameters from this menu.
INTERFACES (ETH) > CONFIG > AUTO NEGOTIATION
The Total Access 600 Series has the capability of auto negotiating the rate and duplex of the connected
Ethernet link. Additionally, when this parameter is set to
O
FF
, the rate and duplex are set manually.
INTERFACES (ETH) > CONFIG > DATE RATE
Defines the Ethernet interface as 100B
ASE
T or 10B
ASE
T. D
ATA
R
ATE
configuration is only available when
A
UTO
N
EGOTIATION
is set to O
FF
.
INTERFACES (ETH) > CONFIG > DUPLEX TYPE
Defines operation on the Ethernet interface as F
ULL
D
UPLEX
or H
ALF
D
UPLEX
. D
UPLEX
T
YPE
configuration
is only available when
A
UTO
N
EGOTIATION
is set to O
FF
.
INTERFACES (ETH) > STATUS
Displays the Ethernet status information.
INTERFACES (ETH) > STATUS > MAC ADDRESS
(Read only) Displays the unique MAC address programmed at ADTRAN.
INTERFACES (ETH) > STATUS > DATA LINK
Displays the current status of the Ethernet link as either U
P
or D
OWN
. If there is an active Ethernet link, the
status displays
U
P
.