Filter
Top Products
61200624L1-1B © 2004 ADTRAN, Inc. 231
DLP-17 Configuring Dual T1 Maps
Introduction
Total Access 6XX T1 TDM systems with the optional DSX-1 interface have a D
UAL
T1 M
AP
feature that
allows two network T1 connections for the termination of data and voice applications. The primary
network
T1 M
AP
can be configured for internal router usage (FT1/24 DS0s maximum) or any other
interfaces. The
DSX M
AP
can be used for FXS/FXO interfaces. There are several steps that must be
followed in order for the Dual T1 Map to be configured successfully. These steps are described in this
DLP.
Prerequisite Procedures
This procedure assumes that the user has access to the Total Access 6XX system menus and has completed
the T1 and DSX-1 interface configuration (as detailed in Appendix D. Configuring the Unit for DSX-1
Applications on page 166).
Refer to DLP-1, Connecting a VT100 Terminal or PC to the CRAFT Port, for details on
making a terminal connection to the Total Access 6XX.
To prevent electrical shock, do not install equipment in a wet location or during a
lightning storm.
Electronic equipment can be damaged by static electrical discharge. Before handling
modules, put on an antistatic discharge wrist strap to prevent damage to electronic
components. Place equipment in antistatic packing material when transporting or storing.
When working on equipment, always place it on an approved antistatic mat that is
electrically grounded.