Filter
Top Products
Total Access 600 Series System Manual Section 4 User Interface Guide
61200624L1-1B © 2004 ADTRAN, Inc. 169
5. APPENDICES (T1 ATM APPLICATIONS)
Appendix A. Voice Gateway Quick Start Procedure (Voice Turn Up)
A typical VoATM application (see Figure 7) uses a Total Access 6XX connected to an ATM network. For
voice applications, a Voice Gateway is needed to interface with the PSTN. Jetstream, Tollbridge,
CopperCom, and LES-CAS are popular Gateway types.
Figure 7. Application Diagram
To configure a Total Access 6XX for use with the Voice Gateway, you need to know the VPI and VCI
used on the ATM network to access the Gateway from this Total Access 6XX. You also need to know the
format for
I
DLE
C
ELLS
and whether D
ATA
S
CRAMBLING
is used on this ATM network. The following
procedure will help you navigate the Total Access 6XX menus for configuring the necessary elements for
VoATM with the Voice Gateway.
Perform the following steps in order to configure the application.
Initial Setup
It is best to configure Total Access 6XX ATM applications by following the order of the top-level menus.
For example, first configure the system parameters using the
S
YSTEM
I
NFO
and S
YSTEM
C
ONFIG
menus.
Next, configure the Layer 1 parameters using the
I
NTERFACES
menu. Once the Layer 1 information is
configured, proceed to the Layer 2 setup using the
L2 P
ROTOCOL
menus.
The following example is for configuring T1 units with ATM firmware. However, all units
using ATM firmware (SDSL, ADSL, SHDSL) may be configured in the same manner. To
configure ATM Voice applications with other network types, disregard the T1 Interface
Setup Instructions and configure your network interface as needed.
V.3
5 TX
DA
T
A
V
OICE
B
A
TT
PWR/N
E
T