Filter
Top Products
Model CM-16 User Guide 7
INSTALLATION
Place a test call…
From another M1 station, call this DN and answer the call by pressing the
Handset Button (to the left of the
∂
button). Verify two way transmission
and hang up by pressing the button to the right of the
∂
button.
Charging Cradle
Refer to Figure 3.
1. Plug the modular cord of the “cradle power adapter” into the jack on
the bottom of the cradle. Route the cord through the retaining tabs of
the molded cord slot. Verify the cradle rests on all four feet and
doesn’t wobble.
2. Plug the transformer into a known working non-switched AC outlet and
place the handset, face up in the charging cradle. There is no power light
on the cradle. However, once the handset is placed in the cradle, the
battery icon will blink indicating the battery is being charged. Should the
icon not blink, check the battery compartment cover to ensure it is properly
closed. If the handset does not easily slide into the charging cradle, the
battery compartment cover is likely not installed correctly.
The Handset (battery) needs to be charged at least 6 hours before use.
Belt Clip
To install the belt clip, snap one arm of the clip into the slot on the side of
the handset and then slide the other arm into the slot on the other side of the
handset until it snaps into place.
Non-switch
e
AC Outlet
Handset
(face down)
Keep the Battery
Near the handset
and don't connect
it until Step 5
5
Figure 3 Charger Preparation
Figure 2 Handset Preparation