Filter
Top Products
6-41
PERIODIC MAINTENANCE AND MINOR REPAIR
6
EAU03782
To install the front wheel
1. Install the speedometer gear unit
into the wheel hub so that the
projections mesh with the slots.
2. Lift the wheel up between the
fork legs.
1
1. Speedometer gear unit
6. Connect the speedometer cable,
and then install the speedometer
cable holder by installing the
screw.
7. Install the brake disc cover by
installing the screws.
8. Install the engine guard by
installing the bolt.
NOTE:
Make sure that there is enough
space between the brake pads
before inserting the brake disc and
that the slot in the speedometer gear
unit fits over the retainer on the fork
leg.
3. Insert the wheel axle, and then
install the axle nut.
4. Lower the front wheel so that it is
on the ground.
5. Tighten the axle nut to the speci-
fied torque.
1
1. Retainer
Tightening torque:
Axle nut:
85 Nm (8.5 m0kgf, 62 ft0lbf)
5RK-9-11(US) 4/26/02 7:16 PM Page 81