Filter
Top Products
Williams Sound
®
Helping People Hear
9
TeleTalker
®
Model TEL 040 Installation Guide & User Manual
Bare Wall Installation
Even if you don’t have a studded wall phone plate, you can
still mount the TeleTalker on any wall surface within six feet
of a standard modular jack and AC outlet. To mount the
phone farther from the jack you’ll need a longer line cord or
a telephone extension cord. In either case, place the AC
power pack in a location which will not be subject to distur-
bance.
Step 1: Measure and mark the wall for mounting screws.
Mark two points 3-
1
⁄4 inches apart for upper and lower
mounting screws. The lower mark should be 48–52
inches from the floor. Use a level to make sure the
marks are aligned vertically.
Step 2: Install the mounting screws (not included).
Use wood screws for stud mounting, anchor screws
for hollow wall mounting. Drive the screws almost
completely in, leaving a
1
⁄8 inch space between the
wall surface and the bottom of the screw head (about
the thickness of two stacked pennies).
Step 3: Reverse the handset hanger to prevent the handset
from falling.
Step 4: Mount the TeleTalker.
Hang the telephone on the mounting screws and
push down gently until it snaps into place
Step 5: Connect the line cord to the jack on the top of the
phone. Plug the other end of the line cord into a
modular wall jack.
Make sure it snaps firmly into place.
Step 6: Connect the AC power pack to a wall AC outlet.
Step 7: Check for the dial tone.
If you can’t hear a dial tone, see In Case Of Difficulty,
page 12.
Note: To disconnect the telephone, squeeze the clip on the
modular plug and pull it out of the jack.