Filter
Top Products
Installation Guide & User Manual TeleTalker
®
Model TEL 040
Williams Sound
®
Helping People Hear
6
Installation Steps
Step 1: Make sure you have a 115 VAC wall outlet and tele-
phone jack within 6 feet of the place you’ve chosen
to install the telephone. If you have an older 4-prong
jack, you’ll need a modular jack adapter.These
adapters are available from electronic, phone, and
other retail stores.
Step 2: Place the Pulse/Tone Switch, located on the side of
the phone, in either Tone or Pulse (Rotary Dial Pulse).
Make sure you choose the correct dialing mode.
Tone dialing will not work if you have only dial
pulse (rotary) service.
Step 3: Set Ringer Volume and Tone Controls to desired level.
(see fig.3)
Step 4: Plug the coiled handset cord into the handset. Plug
the other end into the telephone base. (see fig. 4)
RINGER
OFF LO
HI
RINGER TONE
I
II
III
Ringer Tone Control
Adjusts ringer pitch (I, II, III)
Ringer Volume Control
Adjusts ringer volume (Hi, Lo, Off)
fig. 3:Ringer Controls
fig. 4:Handset Connection
PULSETONE AC 12 V/0.85A
TO TEL. LINE
Pulse / Tone Switch
Switches between touch-tone
and rotary dial modes.
fig. 2:Pulse/Tone Switch