Filter
Top Products
Williams Sound
®
Helping People Hear
13
TeleTalker
®
Model TEL 040 Installation Guide & User Manual
2. The Ringer Volume Control may be set to OFF. Adjust the
switch to LO or HI.
3. Too many phones or phone devices may be connected to
the same line. If so, remove other phones or devices from
line.
4. The Pulse/Tone Switch may be in the wrong position. Your
phone line may be set to accept only pulse dialing. If so,
be sure to set this switch correctly.
Neckloop will not work with the TeleTalker.
1. Only hearing aids with a telecoil coupler (or “T-coil”) work
with neckloops. If your hearing aid does not have a T-coil, it
will not work with a neckloop.
2. Check that the neckloop has been plugged into the
Neckloop/Aux jack on the side of the TeleTalker and that
your hearing aid is set in the “T” position.
3. Try using the neckloop with another device (such as a
radio) to make sure the neckloop is working.
Cochlear Processor will not work with TeleTalker.
1. An attenuator cord (WCA 040) must be used with cochlear
processors. If you do not have this cord, call your dealer or
Williams Sound
2. If you have an attenuator cord and your cochlear processor
is still not working, contact the manufacturer of your
cochlear processor.