Filter
Top Products
Installation Guide & User Manual TeleTalker
®
Model TEL 040
Williams Sound
®
Helping People Hear
8
For Wall Plate Installations
If you prefer, the TeleTalker can also be mounted on a studded
wall phone plate. If you don’t have a phone plate installed,
talk to your phone company or local phone products store.
Step 1: Clip the plastic wall mounting bracket (included) into
bottom of the TeleTalker base unit. (see fig. 7) Make
sure the tabs snap in securely. This will make the
base unit level with the wall.
Step 2: Reverse the handset hanger found in the handset cra-
dle to prevent the handset from falling.
Step 3: Plug the short line cord into the jack on the top of
the telephone and thread the line through the chan-
nel to the cavity on the back of the base unit.
Step 4: Hold the telephone next to the wall-phone jack and
plug the line cord into the jack, leaving any slack in
the base unit cavity. Then push the phone against the
mounting studs so the studs are hooked into the
upper and lower keyhole slots of the phone. Slide
the phone down until it snaps into place. (see fig. 7)
Step 5: Check for a dial tone. If you can’t hear a dial tone,
see In Case Of Difficulty, page 12.
Note: To remove a wall-mounted telephone, slide the phone
up and pull it slightly away from the wall.
Disconnect the line cord by squeezing the clip on the
modular plug and pulling it from the jack.
Wall Mount
Bracket
Short Wall Cord
Studded Wall
Phone Plate
fig. 7:Wall Installation