Filter
Top Products
Installation
RECEIVER VOLUME CONTROL
1. Refer to-
Placing a Call
to establish a phone
conversation.
2. Press BOOST Button.
3. Adjust the rotary VOLUME CONTR OL to a desired
receiving sound level.
4. After hang-up the sound level will go back to
normal level.
5. Next time, during a call, you can press BOOST button
to get your set sound level.
HANDSET BATTERY CHARGING
The battery pack in the handset must be fully charged
10-14 hours before using the telephone for the first time.
1. Place handset in base. The CHARGE LED on base
will light.
2. After batteries are fully charged, check for dial tone by
pressing TALK on handset.
3. When the handset battery gets low, there will be 2
beeps every 30 seconds and the TALK BUTTON will
flash. Return the handset to the cradle for charging.
4
RINGER CONTROLS
HEADSET RINGER
Set switch (back of base) to ON or OFF . Ringer switch
must be ON for handset to ring during incoming calls.
BASE RINGER
The base ringer comes with a volume, pitch and warble
control, allowing it to be tailored to each user.
The Volume Control has three settings: OFF, LOW, and
HIGH. It is suggested that you set the volume control to
high when you first start using your W-400. To do this,
slide the ringer volume control toward the wide end of
the wedge.
The ringer also has a Pitch Control that has three set-
tings: LOW, MED, and HIGH. The low frequency is typi-
cally the easiest for people with partial hearing loss to
hear. It is suggested that you set the pitch control to low
(toward the narrow end of the wedge) when you start
using the phone.
The Warble Rate, or speed of ring can also be varied
from Fast/Slow.
NOTE: The handset will not ring if the handset ringer
switch is set to off. When the hanset is placed on the base
unit, only the base the base ringer will ring, regardless of
which setting the handset ringer is set to. The W-400
ringers will only function independently when the handset
IS NOT placed on the base.
To Replace Battery:
1. Remove
battery cover
2. Install new
battery
3. Close battery cover.
Charge 10-14 hours
before first use.