Filter
Top Products
This equipment complies with
Part 15 and 68 of the Federal
Communications Commission
(FCC) rules for the United States.lt
also complies with rules RSS-210
and CS-03 of Industry Canada (IC)
for Canada.
A label is located on the
underside of the base unit
containing either the FCC
registration number and Ringer
Equivalence Number (REN) or the
IC registration number .You must,
upon request, provide this
information to your local telephone
company.
This equipment is compatible
with inductively coupled hearing
aids.
Should you experience trouble
with this telephone equipment,
please contact:
VTECH COMMUNICATIONS AT
1-800-595-951 1 in the US
and VTECH ELECTRONICS AT
1-800-267-7377 in Canada.
for repair
/
warranty information.
The telephone company may ask
you to disconnect this equipment
from the line network until the
problem has been corrected.
Your
VT
1980
/
VT
1981
is
designed to operate at the
maximum power allowed by the
FCC and IC. This means your
handset and base unit can
communicate only over a certain
distance -which will depend on the
location of the base unit and
handset and layout of your home
or office.
FCC
PART
15
The equipment has been tested
and found to comply with part 15
of the FCC rules. These limits are
designed to provide reasonable
protection against harmful
interference in a residential
installation. This equipment
generates, uses and can radiate
radio frequency energy and, if not
installed and used in accordance
with the instructions, may cause
harmful interference to radio
communications. However, there is
no guarantee that interference will
not occur in particular installation.
If this equipment does cause
harmful interference to radio or
television reception, which can be
determined by turning the
equipment off and on, the user is
encouraged to try and correct the
interference by one or more of the
following measures:
-
Reorient or relocate the
receiving antenna.
-
Increase the separation
between the equipment and
receiver.
-
Connect the equipment into an
outlet or on a circuit different
from that to which the receiver
is connected.
-
Consult the dealer or an
experienced radio
/
TV
technician for help.
FCC
PART
68
The FCC requires that you
connect your cordless telephone to
the nationwide telephone network
through a modular telephone jack
(USOC, RJ11 C or RJl 1
W)
Your telephone company may
discontinue your service if your
equipment causes harm to the
telephone network. They will notify
you in advance of disconnection, if
possible. During notification, you
will be informed of your right to file
a complaint with the FCC.
Occasionally your telephone
company may make changes in its
facilities, equipment, operation, or
procedures that could affect the
operation of your equipment. If so,
you will be given advance notice
of the change to give you an
opportunity to maintain
uninterrupted service.
The base unit contains no user
serviceable parts. The handset
contains a user replaceable battery
pack.
If it is determined that your
telephone equipment is malfunctioning,
the FCC requires that it not be used
and that it be unplugged from the
modular jack until the problem has
been corrected. Repairs to this
telephone equipment can only be
made by the manufacturer or its
authorized agents or by others who
may be authorized by the FCC. For
repair procedures, follow the
instructions outlined under the
VTECH Limited Warranty.
This equipment may not be used
on coin service provided by the
phone company or Party lines.
The REN is useful in determining
the number of devices you may
connect to your telephone line and
still enable the devices to ring when
you receive a call. The general rule
is that the REN value should not
exceed
5.OA total; however,
contact your local telephone
company for the specific number in
your area.