Filter
Top Products
8
Setup
Getting Started
Follow the steps below:
1. Remove the battery cover by pressing
on the indent and sliding downward.
2. Align the two holes in plug with the
socket pins. Insert the plug into
socket. Place the battery pack into
the compartment with the wires in one
of the bottom corners of the battery
pack.
3. Replace the battery cover by sliding
it upwards.
4. If the new battery pack is not already
charged, place the Handset in the
Base unit, or a remote charging
stand, and allow it to charge for 12
hours. After initial charge, a
maintenance charge of 8 hours should
be sufficient.
The original Handset that is shipped with your v 2656 system will be
automatically registered to the Base. This Handset is HANDSET 1.
As you register additional Handsets to the system, they will be assigned extension
numbers in the following order: HANDSET 2, HANDSET 3, and finally HANDSET 4.
After a Handset battery pack is installed, the Handset will automatically begin
SEARCHING FOR BASE (if previously registered), or it will prompt you to
ENTER BASE ID to register the new Handset.
Installation of Battery Pack in Handset
91-005358-050-000 v2656.pmd 8/5/2004, 4:51 PM8