Filter
Top Products
12
Getting Started
Registration of Additional Handsets
Enter Base ID Code
1. After charging the Handset, if
the screen displays
SEARCHING FOR BASE,
press NEW. You will see ENTER
BASE ID. If the screen already
says ENTER BASE ID, go to
step 2.
2. Enter the 15 digit Base Unit ID
code, located on the underside
of the Base Unit.
3. Press
OK
. The Handset will
display: PLEASE WAIT!!
Then put the Handset onto the
cradle.
4. Wait approximately 15 seconds.
The Handset will display:
FOUND BASE
If the Handset displays: BASE
BUSY TRY LATER, this
indicates that the system is in
use. Wait until the Base Unit is
in the idle (on hook) mode, and
repeat steps 2 to 4.
NOTE: Occasionally, it may take
longer than 15 seconds for the Handset
to confirm registration to the Base Unit.
This is normal.
Congratulations! You can now enjoy
the benefits of your multi-Handset
system.
91-005358-050-000 v2656.pmd 8/5/2004, 4:51 PM12