Filter
Top Products
www.vtechphones.com
39
Additional Information
ADDITIONAL INFO
Problem Suggestion
CL is flashing in the
base message display
window.
• You need to set the day and time. Refer to the section(s) on setting the clock in this
user’s manual.
Common cure for
electronic equipment.
If the unit does not seem to be responding normally, then try putting the handset in its base. If it
does not seem to respond, do the following (in the order listed):
1. Disconnect the power to the base.
2. Disconnect the handset battery, and spare battery, if applicable.
3. Wait a few minutes.
4. Connect power to the base.
5. Re-install the battery(ies).
6. Wait for the handset to re-establish its link with the base. To be safe, allow up to one minute
for this to take place.
Troubleshooting
If you subscribe to DSL service:
If you hear noise during conversations and/or your caller ID
features aren’t functioning properly, install a noise lter to the
telephone line between the base unit and the telephone line
jack. Contact your DSL provider to obtain a noise lter.
To single telephone jack (RJ11C)
Telephone line cord
Noise lter
(For xDSL users)