VTech t2351 Cordless Telephone User Manual


 
www.vtechphones.com
32
BASIC OPERATION
Battery Care and Maintenance
After your battery is fully charged, you can expect the following performance:
Operation Operating time
While in use (talking) up to 4 hours
While not in use (standby*) up to 4 days
* Handset is off the base unit or charger but not in use.
• The battery needs charging when:
— A new battery is installed in the handset.
— The phone beeps twice every ve seconds.
— The screen displays BATTERY LOW and the low battery icon.
• Place the handset in the base. The battery is typically fully charged at least 16 hours.
• You can keep the battery fully charged by returning the handset to the base after each use.
Replacing the Handset Battery
1. Remove the battery compartment cover on the handset by pressing on the
indentation and sliding the cover downward.
2. Lift out the old battery and disconnect.
3. Align the two holes in the new battery’s plug with the socket pins, and snap
the plug into place. Snap the battery in the compartment, as described in
Installation, on page 4.
4. Replace the cover by sliding it up into place.
5. The new battery must be charged before using the phone. Place the handset
in the base and allow it to charge for at least 16 hours the rst charge. The
telephone might operate before that, but for best performance, let the battery
charge fully.
Batteries
• If you repeatedly
get a low battery
indicator, even after
charging overnight,
the battery should be
replaced.
• To reduce the risk
of re or injury to
persons or damage
to the telephone,
charge the battery
provided with or
identied for use
with this product only
in accordance with
the instructions and
limitations specied
in the user`s manual.
• Battery power is
consumed whenever
the handset is off the
base unit, even with
the handset is not in
use.
• Once the battery
is fully charged,
you do not have to
charge it again until
BATTERY LOW is
displayed or
ashes. This will
maximize the battery
life.
“CLICK”