Filter
Top Products
www.vtechphones.com
3
Getting started
Basic operation
Getting started
If the handset
will not be used
for a long time,
disconnect and
remove the battery
to prevent possible
leakage.
To purchase
replacement
batteries, visit our
website at www.
vtechphones.
com or call
1 (800) 595-9511.
In Canada, go to
www.vtechcanada.
com or call 1 (800)
267-7377.
•
•
Battery installation and charging
Install the battery as shown below. After installing the battery, you might be able
to make and receive short calls. For best performance, charge the handset for
at least 16 hours before use. When the battery power is low, the handset will
beep, display LOW BATTERY and will ash on the handset screen. Place the
handset in the telephone base or charger to charge the battery when not in use.
See the table on page 53 for battery operating times.
If the battery is depleted, it may take approximately four minutes to charge the
handset before it can resume screen display. The screen will continue to display
LOW BATTERY until the battery has been charged for approximately one hour.
1
3
4
CHARGE
light
2
Plug the battery
securely into the
plug inside the
handset battery
compartment,
matching the
color-coded label.
Place the battery
with the label THIS
SIDE UP facing
up and the wires
inside the battery
compartment. Route
the wires through
the slot at the
bottom of the battery
compartment.
Align the cover
at against
the battery
compartment,
then slide it
upwards until it
clicks into place.
Charge the handset
by placing it in the
telephone base
or charger. The
CHARGE light
will be on when
the handset is
charging.
If the battery
compartment
cover is on the
handset, press
the indentation
and slide the
cover to remove.
5