Filter
Top Products
www.vtechphones.com
38
Answering system
Set the clock
Prior to playing a message, the answering system announces when it was
received. Before using the answering system, set the year, time and day, so that
messages are dated correctly. If the clock is not set before new messages are
recorded, the system will announce “Time and day not set,” before each message
is played to remind you to set the clock.
Press CLOCK. The system announces the clock setting (e.g. year, time and
day), then announces: “To set the clock, press CLOCK.”
Press CLOCK. The system announces the current year.
Press /SKIP or /REPEAT until the system announces the correct year, then
press CLOCK. The system announces the current hour.
Press /SKIP or /REPEAT until the system announces the correct hour, then
press CLOCK. The system announces the current minute.
Press /SKIP or /REPEAT until the system announces the correct minute,
then press CLOCK. The system announces the current day.
Press /SKIP or /REPEAT until the system announces the correct day, then
press CLOCK. After a conrmation tone, the system announces the new clock
setting and exits programming mode.
1.
2.
3.
4.
5.
6.
If you have caller
ID service, the
clock will be set
automatically with
incoming calls,
but you will need
to make sure the
year is correct.
See Set the clock
for instructions
on how to set the
year, time and day
manually.
Press and hold
/SKIP or
/REPEAT while
setting the minutes
or year to advance
or decrease by
increments of 10.
•
•