VTech CS5113 Telephone User Manual


 
3
Getting started
Battery installation and charging
Install the battery as shown below. The battery may have enough charge for
short calls and then completely charge and drain the battery two or three times
every three months afterwards. For best performance, charge the battery for at
least 16 hours before rst use. When the battery power is low, LOW BATTERY
is displayed and ashes on the handset screen.
Insert the plug of the battery as indicated. Make sure it is plugged securely
and matches the color-coded label inside the battery compartment.
Place the battery with the label THIS SIDE UP facing up, and the wires
inside the battery compartment.
Align the battery compartment cover at against the battery compartment,
then slide it upwards until it clicks into place.
Charge the handset by placing it in the telephone base. The handset charge
light is on when charging.
1.
2.
3.
4.
If the handset will not be used for a long period of time, remove the battery
to prevent possible leakage.
To purchase replacement batteries, visit our website at www.vtechphones.com
or call 1 (800) 595-9511. In Canada, go to www.vtechcanada.com or call 1
(800) 267-7377.
1 2 3
4
OPER
DEF
JKL
P
QRS
W
XYZ
TUV
MNO
TONE
ABC
CHARGE
Wall bracket installation
Your telephone base comes with the wall bracket installed, ready for desktop
use. You may also mount your telephone onto a standard telephone wall plate.
Wall bracket installation:
To prepare the telephone base for wall mounting, you need to remove the
bracket if it is currently attached for desktop use. Press the tabs located on
the legs of the bracket to loosen, then lift the bracket up and away from the
telephone base.