Filter
Top Products
9
Getting Started
Wall Mounting
The Wall Mount bracket is designed for use on standard wall mount plates only.
1. Run the power and telephone line cords through the slots in the bracket,
connecting them to the jacks located on the underside of the Base.
2. Plug the AC adapter into an electrical outlet. If the battery pack has not been
previously charged, place the Handset in the cradle, and allow it to charge
for 12 hours.
3. Connect the telephone line cord to the wall jack.
4. Line up the tabs on the wall mount bracket with the slots on the bottom of the
Base Unit. Snap the bracket firmly in place.
5. Mount the Base on the wall. Position the Base Unit so the mounting studs will
fit into the holes on the wall mount bracket. Slide the Base Unit down on the
mounting studs until it locks into place.
Installation
91-005650-040-000t2455.p65 7/21/2004, 3:52 PM9