Filter
Top Products
7
Getting Started
Before You Install
1. Choose a location for the Base near an electrical outlet and a telephone
jack. This phone requires a modular telephone jack and a standard electri-
cal outlet (110v AC) not controlled by a wall switch.
2. Install the Handset battery. Use only VTech batteries.
Installation
a). Remove battery
compartment
cover by press-
ing on the inden-
tation and sliding
downwards.
b). Align the two holes in the plug with the
socket pins, then snap the plug into place.
c). Place the Battery Pack in the compartment
with the wires in the lower right corner. Angle
the top of the Battery Pack under the top
claws first, then snap the bottom of the
pack in. Place the wires under the guide,
located below the Battery Pack.
d) Replace battery compartment cover.
3. Plug the DC connectors to the Base and Charger separately. Plug the AC
adaptors into electrical outlets separately. Connect the telephone line cord
to the jack on the Base, and the other end to a modular telephone jack, as
illustrated below.
4. Place the Handset in the Base or Charger. Charge the battery for 10-12 hours.
91-005650-040-000t2455.p65 7/21/2004, 3:52 PM7