Filter
Top Products
FCC Part 15 Informaon
This device complies with part 15 of the FCC rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation. Privacy of
communications may not be ensured when using this phone.
FCC PART 15.105(b): Note: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no guarantee that inter-
ference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be
try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC RF Exposure Informaon
This product complies with FCC radiation exposure limits under the fol-
lowing conditions:
The base must be placed to allow a minimum of 20 cm (8 inches) between
the antenna and all persons during normal operation.
The base must not be collocated or operated in conjunction with any other
antenna or transmitter.
The handset is designed for body-worn operation and meets FCC RF
exposure guidelines when used with any belt clip, carrying case, or other
accessory supplied with this product. (All necessary accessories are included
in the package; any additional or optional accessories are not required for
compliance with the guidelines.) Third party accessories (unless approved by
the manufacturer) should be avoided as these might not comply with FCC RF
exposure guidelines.
•
•
•
•
•
•
•
Industry Canada (I.C.) Noce
Terminal equipment
NOTICE: This equipment meets the applicable Industry Canada TerminalIndustry Canada Terminal
number. The abbreviation IC
registration was performed based on a Declaration of Conformity indicat-
imply that Industry Canada approved the equipment.
NOTICE: The Ringer Equivalence Number (REN) for this terminal
equipment is marked on the equipment itself. The REN assigned to each
terminal equipment provides an indication of the maximum number of
terminals allowed to be connected to a telephone interface. The termina-
tion on an interface may consist of any combination of devices subject only
to the requirement that the sum of the Ringer Equivalence Numbers of all
the devices does not exceed 5.
Radio equipment
The term IC-
following two conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including interference that
may cause undesired operation of the device. "Privacy of communications
may not be ensured when using this telephone".
Warranty (Limited, 1 Year)
Evidence of original purchase is required for warranty service.
WARRANTOR: UNIDEN AMERICA CORPORATION ("Uniden")
ELEMENTS OF WARRANTY: Uniden warrants, for one year, to the original
retail owner, this Uniden Product to be free from defects in materials and
craftsmanship with only the limitations or exclusions set out below.
WARRANTY DURATION: This warranty to the original user shall terminate
The warranty is invalid if the Product is (A) damaged or not maintained
(C) improperly installed, (D) serviced or repaired by someone other than
an authorized Uniden service center for a defect or malfunction covered