Filter
Top Products
18
19
If... Try...
you don’t hear a dial tone
The display says
Registration Failed
-
-
Making sure the handset is fully
charged, then starting over from the
beginning of this section.
If a handset was previously registered to a base, you have to reset it
so you can register it to a new base (see page 24 or the manual for the
accessory handset).
Using Mul-Handset Features
To use the features in this section, you must have at least two cordless
handsets.
Conference calling
When an outside call comes in, two handsets can join in a
conference call with the outside caller.
To join an ongoing call, press
TaLk/fLash
or
spEakEr
.
To leave the conference call, hang up normally; the other handset
remains connected to the call.
Privacy mode
You can prevent other handsets from joining a call. Start your call
as usual, then press
MEnU/sELECT
; the display shows Call Privacy.
Press
MEnU/sELECT
again to turn privacy mode on (you’ll see in the
display). When you hang up, privacy mode turns off automatically.
As long you have privacy mode on, no other handsets can interrupt
your call. To allow another handset to join the call, press
MEnU/sELECT
twice to turn privacy mode off.
Call transfer
To… Do this...
transfer a call
Press
CLEar/inTErCoM
, then select the
handset you want to transfer the call to
(select All to page all the handsets). When
the other handset accepts the call, you’ll be
disconnected.
cancel a transfer and leave
the call on hold
Press
End
.
cancel a transfer and
return to the call
Press
TaLk/fLash
.
answer a call transfer page
Press
CLEar/inTErCoM
. You can speak to
the transferring handset.
To speak to the outside caller, press
TaLk/fLash
.
1.
2.
Intercom call
Whenever the phone is in standby, you can make an intercom call
between handsets without using the phone line.
You can make an intercom call from any handset, but only two
handsets can be in an intercom call at any time.
If an outside call comes in during an intercom page, the phone
sounds a tone and shows any received CID information. If another
handset hasn't answered the page yet, the phone cancels the page
to let you can answer the incoming call.
To... Do this...
make an intercom page
Press
CLEar/inTErCoM
, then select the
handset you want to talk with (select All
to page all handsets at the same time).
cancel a page Press
End
.
answer an intercom page Press
CLEar/inTErCoM
or
TaLk/fLash
.
leave an intercom call Press
End
.