Filter
Top Products
2) Press select/ch, “Store/Edit Name” appears.
3) Store the name (up to 16 characters) by using the number keypad.
• See the “Steps for entering names and special characters” (see page 27).
• Use
call id/ and /RocketDial/ to move the cursor to the desired location.
• Use
xfer/del to delete characters as needed.
• Press and hold
xfer/del to delete all the characters.
If a name is not required, go to step 4.
4) Press
select/ch to store the name,
“
Store/Edit No.” appears.
5) Press the number keypad to enter the phone number (up to 20 digits),
press
select/ch to store the number.
6) “
Distinctive Ring” appears. Press + or - to move the
pointer to one of the Distinctive Ring options, then press
select/ch.
7) “Speed Dial” appears. Press + or - to move the pointer to
select the Speed dial location (10 locations: SPD1-SPD0).
8) Press select/ch. You will hear a confirmation tone and
“
Done!” appears on the display.
PHONEBOOK[ 26 ]
If you choose not to store a “Distinctive Ring”, simply select
the “
No Selectn” option.
If you choose not to store the name/number as a Speed Dial, simply
select the “
No Selectn” option.
• If you select a Speed
dial location where a
number is already
stored, the new number
will replace the old
number, and the old
number will be stored as
a phonebook location.
• When the memory is
full, you will hear a
beep and “
Memory
Full
” appears. You
cannot store names
and numbers.
• The pause key counts
as one digit. Pressing
redial/p more than
once increases the
length of pause
between numbers.