Filter
Top Products
GETTING STARTED [ 11 ]
GETTING STARTED
Charge the battery pack for at least 15 hours before you start
using your phone.
1 Press in on the battery cover release and slide the cover down
until it comes off.
2 Connect the battery pack connector with the correct polarity
(black and red wires), then insert the battery pack into the
battery compartment.
3 Securely close the battery compartment cover by sliding it up
until it snaps into place.
4 Place the handset on the base.
5 Make sure that the
status LED lights. If the LED doesn’t light,
check to see that the AC adapter is plugged in and that the
handset makes good contact with the base charging contacts.
PREPARING THE BATTERY PACK
Use only the Uniden Battery (BT-905) supplied with
your phone.
TRU246_2.4GHz Owners Manual 7/26/00 9:33 Page 11